PL COMET CS400P coaxial protector male / female

CS400P COMET protector coaxial PL macho/hembra 64940
Available product.
  • CS400P
  • COMET CS400P PL coaxial protector male / female. The lightning protector is designed to protect your...

    More info

  • 36,00€
  • VAT not included

We're working in our new page, i'ts possible that you discover some mistakes.

In that case, you can notify us

clicking HERE..

COMET PL coaxial protector CS400P male / female.
The lightning protector is designed to protect your transceiver and / or recipients of a discharge current of high amperage produced by a lightning strike near his installation, provided you have done and correct connection a grounding.

COMET CS400P PL coaxial protector male / female.

COMET CS400P PL coaxial protector male / female.

COMET CS400P PL coaxial protector male / female.

Features:

When the protector detects a large increase in current or voltage, it automatically directs you to the ground avoiding overloading of equipment.

Great ability to withstand high currents in a compact size.

Great time, thousands of potential downloads.

Extremely sensitive to any excess supply.

Lightning Protector made from a coaxial core low insertion loss and wide bandwidth

How to use:

1.-To properly use the protector must be installed between the coaxial cables and / or as close to the transceiver / receiver.

2 .- For a correct connection terminal grounding, use copper wire of 2.5 to 3mm in diameter. The end of copper wire grounding, should be buried to a minimum depth of 1 meter. Or connection to ground and effectively verified.

3 .- The protector is not water resistant for outdoor use must be properly protected by a waterproof case or similar.

4 .- Figure 1 shows a recommended installation using 2 and 3 protective earthing points, providing great protection against shock.


Connector: MR / MR

:0-500MHZ Frequency Range

Insertion Loss: <0.1 dB

Impedance: 50 Ohm

VSWR <1.1

Maximum Power: 500W PEP

Minimum Voltage Radiation: 100VCC & / - 15%

Minimum Voltage Shock Wave (1x 40) us: 1000 V

Ta Minimum Current Shock Wave (1x40) us: 6000#C/font>

Minimum Repeat Shock Wave (1x 40) or 500 descarg./503A --- 400 VDC + / - 20%

Isolation 100 VDC: 10000 +



Measures mm.: 66x41x20

Weight: 95g

Notes:

In order to give the tower a properly grounded, to connect to it using copper wires (preferably) or heavy gauge Lumini order to maintain an earth resistance measurement less than 10 co


FEATURES

Connector: MR / MR

:0-500MHZ Frequency Range

Insertion Loss: <0.1 dB

Impedance: 50 Ohm

VSWR <1.1

Maximum Power: 500W PEP

Minimum Voltage Radiation: 100VCC + / - 15%

Minimum Voltage Shock Wave (1x 40) us: 1000 V

Ta Minimum Current Shock Wave (1x40) us: 6000"0

Minimum Repeat Shock Wave (1x 40) or 500 descarg./503A --- 400 VDC + / - 20%

Isolation 100 VDC: + 10000



Measures mm.: 66x41x20
Weight: 95g