TS-2000 Emitting E2 KENWOOD OF VHF BASE HF// UHF
TODOD WAYS
TS2000 Emitting E2 KENWOOD OF VHF BASE UHF HF// ALL
WAYS GARANTIA KENWOOD IBERICA SPAIN the new transceiver multiband all
way TS-2000 E2 de Kenwood can be compact, but it is equipped with all
the characteristics that would hope to find in an equipment of first
quality.
TS2000 Emitting E2 KENWOOD OF VHF BASE UHF HF// ALL WAYS
The new transceiver multiband all way TS-2000 E2de Kenwood can be compact, but it is equipped with all the characteristics that would hope to find in an equipment of first quality.
1200 MHZ DO NOT INCLUDE I MODULATE BAND
Digital signal processing IF
The TS-2000/B2000 has a very effective behavior as far as the processing of DS. The digital technology outpost of Kenwood turns analogical signals digitalises in real time, allowinga digital processing like filtrate IF, the slope tone, the automatic rectangular depression and the AGC. The DSP of stage IF in the reception and main transmission of band %u2013 including bands V/UHF %u2013 allows to the greater margin of control and a yield without precedents.
Detection DSP DSP of stage IF, means that the TS-2000/B2000 offers a detection with a distortion significantly more loss and a quality significantly more discharge in all ways (FM: Digital filter high frequency)
Digital Filtrate There is absolutely no necessity to buy optionalfilters: it is had digital filters IF to each one of ways (FM: digital filter high frequency), offering a yield superior to any other possible one with analogical circuitry. When doing towork the ways SSB/FM/AM, this digital filtrate allows so much a variation of high cut-off frequency like loss. Using the slope tone it can eliminate the noise with a minimum effect in the quality of the sound. In the way A.M., the high cut-off frequency can reduce the interference controlling in bandwidth of useful passage of IF %u2013 to receive emissions of short wave. In way CW, function WIDTH it is complemented by the central frequency shift, allowing that the interference of the adjacent signals is detuned. This function WIDTH also provides capacities of reduction of noise in FSK with 4 steps available: 250, 500, 1,000 and 1.500Hz. and thanks to the DSP of stage high frequency, the independent control of the high and low cut-off frequencies (12 steps each one of them) also provide a capacity of slope tone in FM.
Detection with DSP
With the DSP process, the TS-2000 provides a relation signal-noise significantly better than a comparable analogical circuit, with less distortion and greater quality of detección.
Rectangular Depression Automatic IF
Since it is working with a DS, Rectangular Depression Automatic IF (main band, way SSB) can provide an extraordinarily precise filtrate of the carrier frequencies of the emission and the sources of continuous pulsation. The interferente pulsation is extracted of a much more precise form that in the conventional analogical systems, and the Automatic Rectangular Depression will even track the changes of the pulsation signal (the speed of tracking can be varied in 5 steps).
AGC IF
Digital circuit AGC (only main band) offers characteristics of very fast emission, exceeding even to the best analogical designs. You can to size select a time of emission (20 steps) for each one of the ways, except FM.
Advanced design
Digital signal processing high frequency
The DSP also executes in stage high frequency, offering the functions of Cancellation of Pulsation and Automatic ToneCW. Also it allows to obtain an important reduction him of the noise and to apply improvements to size to his transmitted voice.
Cancellation of Pulsation The Cancellation of Pulsation Automatic, available for the main band (ways SSB and A.M.), immediately eliminates interferentes multiple pulsations with a wished signal. It works well in combination with Rectangular Depression Automatic IF (SSB).
Cancellation of Manua Pulsationl A new function of Cancellation of Manual Pulsation, that works like manual a rectangular depression high frequency, can be used in all the ways %u2013 although he is particularly efficient in CW.
Automatic Tone CW You no longer must fit plus the VFO while %u2013is working in CW Automatic Tone CW does by you of automatic form fitting the VFO to its tone previously fit pressing a key.
Reduction of Noise There are 2 types of noise reduction: LEM(NR1) and SPAC (NR2). The LEM (Method Enhancer of Line) %u2013 available for all the ways in main band and FM/AM in the sub-band %u2013 automatically forms a form of filter around the objective signal to obtain a capacity of dynamic reduction of noise, to size. The improvement degree also can adjust manually for the use in the main band. Function SPAC (Processed Automatic Correlation/of Voice) uses an algorithm of special statistical correlation/to extract weak signals that they are masked at heart of the noise. Although he is available for all the ways in the main band, he is specially useful for hard conditions of CW. The adjustment of time of correlation can pay attention to 10 passages between 2ms and 20ms.
Modeled of Audio TX 3 forms exist to personalize the quality of audio with the DSP: the ecualizador TX/RX (SSB/FM/AM), the bandwidth of filter TX (SSB/AM), and the processor of voice (SSB/FM/AM). Ecualizador TX/RX offers 4 positions of frequency response in SSB, FM and A.M.: intensifier of high frequencies for one better clarity, passage of formante to diminish the external sounds, intensifier of low frequencies to obtain a more intense sound,and conventional way to obtain a sound %u20Çanalógico%u201D. In the transmission of SSB and A.M. you can choose between 6 positions of bandwidth of filter TX according to your requirements of operation and microphone. The voice processor works in three bands (SSB, FM and A.M.) to obtain a high compression and a minimum distortion.
Greater Power and Yield
Tone of Group DX (Group of Paquetes) The 2 TNC of simple Chips fulfills protocol AX.25 of tone of group DX. The information of group DX receivedin the sub-band not only appears in the liquid crystal visualizer: also it can be used to fit of instantaneous form the main frequency of band to group information. They can be stored up to 10 units of information in memory.
Listening of Double Channel The provision of sub-bands and main band allows the listening of double channel. This tuning multiband all way can even receive from simultaneous form two frequencies in the same band, allowing combinations like HF + V/UHF; VHF VHF +; UHF UHF and VHF + UHF + (the sub-band is used exclusively for the reception of 144/430MHz in FM/AM). This means, for example,that you can obtain local data in V/UHF operating with HF in the band principal.
Communications Via Satellite The operations via satellite have been improved with the IF-DSP, 10 dedicated channels of memory, the adjustment of frequencies with Doppler effect (manual) and the capacity to choose between normal displacement or inverse for the tracking.
Section of Transmitter of High productivity This transceiving one is the perfect election for applications of FSK, moving bodies and answer, giving up to 100 (AM:25) watios ones in the bands of HF/50/144MHz. The exit is of 50 (AM:12%u20195) watios ones in the band of 430MHz, and 10 (AM:2%u20195) watios ones in 1.200MHz. But there is only no power: the built-in TCXO assures a stability excellent frequency - +-0%u20195ppm (except in way FM). * The minimum exit is of 5 watios for the bands of HF/50/144/430MHz, 1 watio for 1.200MHz.
Characteristics In addition to the new function of Automatic Tone, there is one complete range of characteristics CW. The adjustments of time of retardation and connection of semi-interruption/complete interruption are completely adjustable. In semi-interruption the time of retardation between the liberation of the key and the way of active reception can adjust between 50ms and 1.000ms. When using operation VOX the time of retardation can adjust between 150ms and 3.000ms. Among other characteristics CW the control of tone (400-1.000Hz), the control of lateral tone with adjustment of volume of 10 steps, the adjustment of time of ascent based on DSP, and inverse way CW are included.
Characteristics FSK When working in way FSK, it can select displacement frequencies (170, 200, 425 and 850Hz) and connect so muchthe KEY polarity as the Alto/Bajo tones to adapt to his device RTTY. In addition, inverse function FSK allows him to adapt the methods of transmission to the other part if it is necessary, for example changing frequency BFO of LSB (normal) to USB (inverse).
Characteristics of Communication of Datos The bandwidth of the filter of packages is completely selectionable to adapt at the speed of the packages, and you also can connect the entrance levels/exit ACC2 (PKD). For way PSK31, the menu he offers a filter of IF-DSP with bandwidth of 100Hz.
Improved facility of Operation
Automatic tuner of Antenna The tuner of suppressed antenna %u2013 that alsoworks when the radio is in the reception way %u2013 includes the bandsof liking between 1%u20199 and 50MHz, with blockade of tuning fast when using preadjustments.
300 Channels of Memory This transceiver provides a bank of 300 memories(more 1 channel of call for each one of the bands), with 290 assignable by name and 10 available ones for the programmable search. The function to advance and to back down allows to see the contents him of the memory, the copy of memory channel sends the content from a channel to another one, the memory of blockade changes the map search to exclude certain channels, and the displacement of memory modifies the frequency stored in a channel. In addition,%u20Çrápidas%u201D are 10 memories to capture a present operation the ideal flight %u2013 for the operation of answer.
Multiple functions search A complete range of functions is provided search, including search of MHz, search of memory, and search of call.The way of group search includes all the 300 channels of memoryin groups of 10, and the search of programmable band will look for a dispersion of frequency between two adjustments of VFO (the function halting of the search stops the search during 5 seconds). A newcharacteristic is the programmable slow search, that automatically will reduce the speed to verify a frequency band in which it is interested. As well as to vary the speed of tracking, can choose between occupy-halting-renewal activated by means of time (TO) or driven by means of carrier (CO).
System of Menu It can be acceded to all the power and all the functions of the TS-2000/B2000 by means of the interface of visualizerdriven by means of menu of the frontal panel. Also the characteristic of Fast Menu can activate to only accede to more the habitually used functions.
CHARACTERISTICS
Other Characteristics
Liquid crystal visualizer with light of color bottom amber, great Frontal keys with bottom light Compatible with unit of optional digital recording DRU-Á Announcement of operation of key with sintetizador of voice VS-3 (optional) Programmable function keys Converter of current (it visualizes until 19%u201999999GHz) Control of RF gain Silencer with all the ways Simple visual search Tester automatic simplex Deviation of automatic repeater (144MHz) Built-in manipulator Sound suppressor Automatic disconnection
AREA CLIENTE 
TS2000E2
a partir de 43,36 € al mes 
Descripción del Producto 
