COMET CS400R coaxial protector PL / F

CS400R COMET protector coaxial PL hembra/hembra 64939
Available product.
  • CS400R
  • COMET CS400R coaxial protector PL / F The lightning protector is Designed to Protect your transceiver...

    More info

  • 29,80€
  • VAT not included

We're working in our new page, i'ts possible that you discover some mistakes.

In that case, you can notify us

clicking HERE..

COMET PL CS400R coaxial protector female / female.

The lightning protector is Designed to Protect your transceiver and / or current recipients of a discharge of high amperage produced by a lightning strike near historical installation, Provided You Have Done and correct connection to grounding.


COMET PL CS400R coaxial protector female / female.

COMET PL CS400R coaxial protector female / female.

Features:

When the protector detects a large Increase in current or voltage, Automatically it directs you to the ground Avoiding overloading of equipment.

Great Ability to withstand high currents in a compact size.

Great time, Thousands of Potential downloads.

Extremely sensitive to Any Excess current.

Lightning Protector coaxial core made of a low insertion loss and wide bandwidth

How to use:

1.-To Properly use the protector must be installed Between the coaxial cables and / or as Close to the transceiver / receiver.

2 .- For a correct grounding terminal connection, use copper wire of 2.5 to 3mm in diameter. The end of copper wire grounding, should be buried to a minimum depth of 1 meter. Or connection to ground and Effectively verified.

3 .- The protector is Not water resistant for outdoor use must be Properly protected by a waterproof case or similar.

4 .- Figure 1 shows a recommended installation using two guards and three grounding points, Providing great Protection against shock.


Connector: MR / MR


:0-500MHZ Frequency Range

Insertion Loss: <0.1 dB

Impedance: 50 Ohm

VSWR <1.1

Maximum Power: 500W PEP

Minimum Voltage Radiation: 100VCC + / - 15%

Minimum Voltage Shock Wave (1x 40) us: 1000 V

Current Minimum Ta Shock Wave (1x40) us: 6000"0

Minimum Repeat Shock Wave (1x 40) or 500 descarg./503A --- 400 VDC + / - 20%

Isolation 100 VDC: + 10 000



Measures mm.: 66x41x20

Weight: 80g

Notes:

To Give The tower to Properly grounded, to connect to it using copper wire (preferably) or heavy gauge Lumini order to Maintain an earth resistance less Than 10 co Measurement


FEATURES

Connector: MR / MR

:0-500MHZ Frequency Range

Insertion Loss: <0.1 dB

Impedance: 50 Ohm

VSWR <1.1

Maximum Power: 500W PEP

Minimum Voltage Radiation: 100VCC + / - 15%

Minimum Voltage Shock Wave (1x 40) us: 1000 V

Current Minimum Ta Shock Wave (1x40) us: 6000"0

Minimum Repeat Shock Wave (1x 40) or 500 descarg./503A --- 400 VDC + / - 20%

Isolation 100 VDC: + 10 000



Measures mm.: 66x41x20

Weight: 80g